Rock Hard Rear Bumper/Tire Carrier for Jeep Wrangler JK

The Rock Hard Jeep JK Wrangler Rear Bumper/Tire-Carrier is the only JK rear bumper on the market today that is made out of 1/4" thick plate steel. Designed with tapered ends for increased departure angles, this bumper will hold up to a 38" tire, comes standard with an integrated Class 2 hitch receiver, CB antenna mount, a horizontal Hi-Lift Jack mount with padlock provision and two 5/8" x 2-1/2" CNC D-Ring shackle mount with tabs that are welded on front, go through bumper and then are welded on the backside as well. All necessary hardware required for the installation is provided and an optional muffler shield, jerry can mounts and a trail rack are all available for purchase separately.

The Rock Hard Jeep JK Wrangler bumper tire carrier swings on 1 1/4" shaft, 2 3/4" hub with upper and lower sealed tapered roller bearings. Zerk fittings allow you to fill the hinge with grease. Also, notice the A-Frame swing stop built into the bumper.

 

Easy open latch. Just lift lever to open
self-latching design. To close, simply push it shut. Also included is a double safety latch with hard plastic rest and rubber stop for a rattle free operation.

 

Spring loaded auto-locking pin system. Tire carrier locks in the open position so it will not swing back at you. To close, just lift tee handle on the pin and let it swing shut.

 

The Rock Hard Jeep Bumper has an Integrated class 2 trailer hitch comes complete with safety change mounts.