Rear Axle Bridge, 14 Bolt, Welded

• Specifically designed for the 14 Bolt rear axle.
• Pre-welded (still needs to be welded on your axle).
• Design puts the joints 8-1/2" above axle center line.
• Heavy Duty 1/4" thick laser cut and CNC bent material, boxed design.
• Acts as a bridge and an axle truss!
• The links are mounted "sideways" inside the bridge to keep your link joints in a "neutral" position so they do not "max out" during extreme articulation and cause damage to the joint.
• Bridge end plates fit 2-3/4" or 3" diameter axle tubes.
• This part is designed to work with Triangulated 4 link or "Y" 3 link suspensions!
• Joint mount is made 2-5/8" wide and for a 9/16" bolt.

NOTES:
1) This kit requires welding to properly install it on your axle housing.
2) For maximum performance and articulation you need to tack the bridge in place and cycle the suspension.